Release 0.7
-----------
widget3  works, man!!!!  just burned my first
flash chip!!!!  on April 22nd, 1999.  yee-ha!

changs....lots of errors...hmmm...1 second timeout must
go...takes too long...also, should chill on out the
printing...blame it all on the 2181 uart....

Release 0.8
-----------
This release lets you burn images and boot off of
them.

1) Boot up kit using your current monitor image.
2) Burn newmon.s2 into your Boot device.
3) Erase sector 7 of your flash device (address 0001c000)
4) Burn flasher.exe into slot 7.
5) Construct buttons interface on FL
6) Hold buttons down while booting to get to various images.

To Burn an s2 image:
--------------------
Load flasher.exe into your DSP's SRAM
Put an AMDF9010 Flash Chip into the U2 socket
   on your EZ-Kit Lite.
Run DFS.EXE from DOS.
Set Read Address to 00000000
Read a byte from that address
Erase it
Program it
Verify it 

to erase a sector:
------------------
run flasher.exe
read from the first byte in the sector you
  want to erase.
Erase the sector
Read bytes from it, to make sure.
